Adjusting Cursors; Enabling Edge Blending - Christie H Series User Manual

Warping and blending

Hide thumbs Also See for H Series:

Table of Contents

3. In the Warp section select the warp type: Curve or Linear.

4. To increase or decrease the grid number, use the Grid Number slider.

You can also use Ctrl+ or Ctrl-.

5. To increase or decrease the move pitch, use the Move Pitch slider.

You can also use Ctrl+ or Ctrl-.

6. To select the cursor, click in the grid or type W, A, S, or D.

The selected cursor changes to orange.

7. To move the cursor, use the arrow keys.

8. To revert to the previous warp table, click Undo.

Adjusting cursors

Adjust the inner and outer cursors after enabling warping.

1. Start with a minimal number of grids and gradually increase the number of grids.

Christie recommends starting with a 2x2 setup. Using fewer grids allows for less warping.

2. Adjust the outer cursors as shown in red below.

3. Adjust the inner cursors as shown in green below.

Adjusting the outer cursors after adjusting the inner cursors, removes the inner cursor

settings.

Combine several projected images into one single, seamless image with edge blending.

The warping adjustment determines if the blending area matches another blending area.

1. In the Projector Control dialog, switch to the Edge Blending tab.

H Series, HS Series, GS Series (700, 850) Warping and Blending User Manual

020-000807-02 Rev. 1 (07-2016)

Warping and blending

Table of Contents

Hs series Gs series 700 800