Tdd-3D Sync Delay; Tdm-3D Mode - Christie Crimson Technical Reference

Commands
Command Description
SZP <value> Changes the aspect ratio of the display. This
command is only available if video
electronics are on. (Saved value)
TDD–3D Sync Delay
Configures where the sync pulse occurs in relation to the transition from on time to off time in the
DMDs, in microseconds.
Only applies to: Mirage HD25, Mirage WU25
Commands
Command Description
TDD? Returns the 3D emitter delay value on main
video. (Read-only)
TDD <value> Configures where the sync pulse occurs.
(Saved value)
Enabled when the selected signal is a 3D
signal, 3D mode is enabled, and 3D Sync
Out is set to Emitter.
TDM–3D Mode
Controls when input signals are processed as 3D or not.
Only applies to: Mirage HD25, Mirage WU25
Crimson and Crimson Mirage Technical Reference–Serial Commands
020-102660-01 Rev. 1 (07-2018)
Copyright 2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Serial API commands
Values
0 = Allows the projector to determine when to
scale video (Default)
1 = None
2 = Full size (stretch horizontally and vertically)
3 = Full width (stretch horizontally)
4 = Full height (stretch vertically)
Values
—
0 = Lines up the sync pulse with the
transition (Default)
Negative value = Configures the sync pulse
to be slightly before the transition
Positive value = Configures the sync pulse
to be slightly after the transition
48