Opening Previously Saved Settings; Applying Previously Saved Settings; Configuring Edge Blending - Christie H Series User Manual

Warping and blending

Hide thumbs Also See for H Series:

Table of Contents

3. Navigate to the location where the file will be saved, and select Save.

Opening previously saved settings

After starting a new session, instead of creating new warping, edge blending, or black leveling

settings, you can open the previously saved settings.

From the File menu, select Open.

If you modified the general settings or made adjustments for warping, edge blending, or black

leveling, you can revert to the previously saved settings.

1. From the File menu, select Open.

2. Switch to the General tab.

3. In the Network section, enter the required IP address.

4. Select Connect.

5. To apply the previous settings, select Reconfigure.

Combine several projected images into one single, seamless image with edge blending.

The warping adjustment determines if the blending area matches another blending area.

1. In the Projector Control dialog, switch to the Edge Blending tab.

2. To enable edge blending, select Enable.

3. For the Top boundary, in the Start list, enter the start of the blending area and select Enter.

4. In the Width list, enter the width of the blending area and select Enter.

When setting the blending width make sure the edge blending marker is superimposed on the

other blending marker.

5. To see the boundaries edge blending, select Enable Marker.

6. To change the color of the start marker of the blending area, select the Start color box and

select a color.

H Series, HS Series, GS Series and Inspire Series User Guide–Warping and Blending

020-000807-03 Rev. 1 (01-2024)

If printed, please recycle this document after use.

Warping and blending

Table of Contents