Installing And Connecting Batteries In List 93 Battery Tray (If Furnished); Important Safety Instructions; Battery Manufacturer Information - Emerson NetSure 710NPBA Installation Instructions Manual

Installation Instructions
Spec. No. 581127000 (Model 710
INSTALLING AND CONNECTING BATTERIES
IN LIST 93 BATTERY TRAY (IF FURNISHED)

Important Safety Instructions

Danger: THIS EQUIPMENT IS USED IN CONJUNCTION WITH LEAD-ACID

Battery Manufacturer Information

Refer to System Application Guide SAG581127000 for specifications and manufacturers
of the batteries to be installed in this power system.
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
)
NPBA
BATTERIES. WORKING NEAR LEAD-ACID BATTERIES IS DANGEROUS!
Batteries contain sulfuric acid.
Batteries may generate explosive gases.
Batteries are an energy source that can produce high amounts of
electrical current.
FOR THESE REASONS, IT IS OF CRITICAL IMPORTANCE THAT YOU
READ THESE INSTRUCTIONS AND FOLLOW THEM EXACTLY.
WHEN WORKING WITH LEAD-ACID BATTERIES:
Wear complete protection for eyes, face, hands, and clothing.
Examples are safety goggles or face shield, a rubber apron, and
gloves.
If battery acid enters your eye, immediately flush your eye with
running cold water for at least 15 minutes. Get medical attention
immediately.
If battery acid contacts skin or clothing, wash immediately with soap
and water.
NEVER smoke or allow a flame or spark near batteries.
NEVER allow a metal object, such as a tool, to contact more than one
terminal of a battery at a time, or to simultaneously contact a terminal
and a grounded object (such as the battery enclosure). Even a
momentary short circuit can cause sparking or explosion. To avoid
such short circuits:
 Remove watches, bracelets and rings.
 Use only tools having insulated handles.
 If insulated tools are not available, completely cover tool handles
with a minimum of three half-lapped layers of vinyl electrical tape.
 Ensure that wrenches with more than one working end have only
one end exposed.
Always follow the battery manufacturer's recommendations and
admonishments.
Chapter 4. Making Electrical Connections
IM581127000
Issue AB, March 22, 2012
Page 81