Table of Contents
Advertisement
IM581127000
Issue AB, March 22, 2012
Installing TPL-B Fuses
Refer to the following procedure and install appropriately sized TPL-B fuses into the
proper fuseholders in the distribution cabinet.
Procedure
Note: Refer to Figure 2-13 as this procedure is performed.
Fuse Installed in
Open Fuse Case
(rear view)
Fuse Installed in
Closed Fuse Case
(rear view)
Page 22
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
1) Open the distribution cabinet's front door by turning the latch in the
counterclockwise position.
2) Remove the fuse case from the mounted fuse block by grasping its handle and
pulling it straight out.
3) Verify that an 18/100 ampere alarm fuse is present in the GMT-type fuseholder
located on the fuse block and that a plastic safety cover is installed on this fuse.
4) Open the fuse case.
5) Install the TPL fuse into the fuse case.
6) Close the fuse case.
7) Firmly plug the fuse and fuse case into the fuse block.
8) Record all fuse sizes on the cards provided within the fuseholders.
9) Close the distribution cabinet's front door. Turn the latch clockwise to secure the
door.
GMT-18/100A Alarm Fuse
GMT-X Safety Fuse Cover
Figure 2-13
Installing TPL-B Fuses
Chapter 2. Installing the System
Spec. No. 581127000 (Model 710
(P/N 248610301) and
(P/N 248898700)
(Both are provided
w/ fuseblock)
Fuse Case
Open Fuse Case View
Installation Instructions
NPBA
Fuseblock
(P/N 516241)
TPL Fuse
)
Advertisement
Table of Contents
