Table of Contents
Advertisement
IM581127000
Issue AB, March 22, 2012
SWITCH SETTING ON SM-DU+
SM-DU+ uses two (2) 8-bit switches for parameter setting (SW1 and SW2). Refer to
Table 3-3 for SW1 and SW2 settings. Refer to Figure 3-5 for SW1 and SW2 locations.
Perform the following procedure to verify the factory settings. This procedure can also be
used to make adjustments on a replacement circuit card.
Procedure
SW1 and SW2
In this system, switch settings
must be in the positions shown.
Page 34
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
1) Ensure SW1 and SW2 are set per Table 3-3. Refer to Figure 3-5 for location.
Switches SW1 and SW2 are located
in this corner of the SM-DU+.
SM-DU+
Figure 3-5
Optional SM-DU+ Switch Location and Settings
Chapter 3. Setting Jumpers and Switch Options
Installation Instructions
Spec. No. 581127000 (Model 710
SM-DU+ and
Shunt Interface Board
)
NPBA
Advertisement
Table of Contents
