Advertisement
Installing & Wiring
1. To disassemble the device, loosen (do not remove) the two front retaining screws from the plug and remove the plug base assembly
from the plug housing.
2. Remove plug base and insulator clamp from the plug housing. Note orientation of insulator clamp before complete removal.
3. Remove the four clamp screws from the insulator clamp.
4. Slide plug housing over cord. The self-sealing neoprene bushing will adjust to the cord diameter.
5. Strip the cable jacket and individual conductors as below:
6. Fasten the individual conductor wires to the proper terminals (in the plug base assembly) as follows:
For 125 V: GREEN wire to lug terminal "G".
(terminal with grounding strap)
WHITE wire to lug terminal with WHITE DOT.
BLACK wire to remaining lug terminal.
Tighten the terminal screws to a torque of 15 in.-lb.
7. Slide insulator clamp down the cord and position over terminals. The insulator clamp has two slots which engage with the arc
barrier walls, providing proper orientation. Continue to slide the insulator clamp over the cord until it seats against the plug
base gasket.
NOTE: Configuration of the plug housing is such that the plug base assembly and insulator clamp assembly can only be installed
in one position.
8. Place the cord clamp according to the cable diameter (0.538–0.639 inch) and tighten the four clamp screws to a torque of 15 in.-lb.
NOTE: DO NOT attempt to over-tighten the screws or bottom the clamp.
9. Slide the plug housing over the insulator clamp assembly and tighten the two retaining screws.
Appleton • 1.800.621.1506 • www.appletonelec.com
Appleton • 1.800.621.1506 • www.appletonelec.com
FIGURE 2
For 250 V: GREEN wire to lug terminal "G".
(terminal with grounding strap)
Other two wires to remaining lug terminals.
FIGURE 3
FIGURE 4
330100-000 Rev. F 05/15 • Page 2 of
Advertisement
