Table of Contents
Advertisement
Installation Instructions
Spec. No. 581127000 (Model 710
INSTALLING CIRCUIT BREAKER
2-pole breaker shown.
3-pole and 4-pole breakers similar.
INSTALLING CIRCUIT BREAKER GUARD
ALARM WIRING (BREAKERS W/OUT SHUNTS)
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
)
NPBA
Apply anti-oxidizing compound to busbar mating
surfaces before mounting circuit breakers.
ALARM WIRING (BREAKERS WITH SHUNTS)
Figure 2-14 (cont'd from previous page)
Installing a GJ/218 Circuit Breaker (2-Pole, 3-Pole, 4-Pole)
Chapter 2. Installing the System
Issue AB, March 22, 2012
Alarm jumper connectors.
Holes to route shunt jumper through (if applicable).
ON
OFF
Busbar
IM581127000
1/4" Hardened
Flat Washer
1/4" Belleville
Lock Washer
1/4-20 x 3/4" Bolt
(4 places)
Torque to 60 in-lbs.
Page 25
Advertisement
Table of Contents
