Dip Switch Modules - Emerson Lorain CIP 4890 AP6C55CB User Manual

52 Configuring and operating the system
5.3.1.

DIP switch modules

Three DIP switch modules (S1, S2 and S3), located on the upper edge of the
Controller CIP, are used to set the thresholds of functions as illustrated in
Figure 5.1 and as described in Table 5.1, Table 5.2, Table 5.3 and Table 5.4.
Figure 5.1 – Location of DIP switch modules and output relay contacts on Controller CIP
UM6C55C (P7000597)
Standard 10.00 (March 2008)
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
CAUTION!
Prevent damages caused by electrostatic
discharges (ESD).
This equipment includes solid-state devices sensitive to
electrostatic discharges (ESD). When performing
maintenance or repair procedures on an AP6C55CA/CB
Lorain CIP power system, it is therefore required to wear an
appropriate antistatic device (a bracelet for example) that is
properly connected to a designated antistatic grounding point
(on a framework, an anti-static floor mat or workbench mat,
etc.). ESD-protective packaging material shall also be used
when carrying/shipping ESD sensitive material.
Note 1: It is recommended to remove the controller from the shelf
completely to facilitate the settings of the DIP switches. When the
controller is reinstalled on the shelf, it will automatically reboot and
validate the new configuration and associated values.
Note 2: The factory default settings of the DIP switches are shown in the
shaded lines in Table 5.2, Table 5.3 and Table 5.4.
Lorain Power System (AP6C55CA/CB)
User Manual