Figure 2-2 Installing Expansive Pipe; Figure 2-3 Fixing Cabinet With Tap - Emerson ACTURA Flex 48330 User Manual

Power system

Hide thumbs

Table Of Contents

Table of Contents

Chapter 2 Installation

not to shake the drill, and try to keep as vertical as possible to the ground, as

shown in Figure 2-2.

Step 3: install expansive pipes.

Clean the dust, and insert the expansive pipe into the reserve hole, knock it down

gently using a hammer until the top of the expansive pipe is level with the ground,

as shown in Figure 2-2.

Step 4: place cabinet in position

Move the cabinet to the installation position aligning the installation holes of the

cabinet to the expansive pipe on the ground.

Step 5: fix the cabinet

After the cabinet is in position, make some horizontal and vertical adjustments.

Insert some iron pieces under the lower edge and corner of the cabinet to adjust

the vertical obliquity of the cabinet within 5 degrees. Finally, screw down the tap

bolt with plain washer and spring washer into the expansive pipe, and tighten it with

wrench. The cabinet fixation is illustrated in Figure 2-3.

2) Clean the dust

1) Drill vertically