Step 7: Check The Installation; Step 8: Apply Ac Power And Check The Leds; Step 9: Manage The Switch - NETGEAR GS418TPP Hardware Installation Manual

Easy-Mount 16-Port Gigabit High Power PoE+ Smart Managed Pro Switch with 2 SFP Ports (240W)
To connect devices to the switch's RJ-45 ports:
1. Select a Category 5e (Cat 5e) or higher rated (Cat 6) cable terminated with an RJ-45
connector.
2. Connect each device to an RJ-45 network port on the switch front panel.

Step 7: Check the installation

Before you apply power to the switch, perform the following steps.
To check the installation:
1. Inspect the equipment thoroughly.
2. Verify that all cables are installed correctly.
3. Check cable routing to make sure that cables are not damaged or creating a safety
hazard.
4. Make sure that all equipment is mounted properly and securely.

Step 8: Apply AC Power and Check the LEDs

The switch does not provide an on/off switch. The power cord connection controls the
power.
Before connecting the power cord, select an AC outlet that is not controlled by a wall
switch, which can turn off power to the switch.
To apply AC power:
1. Connect the end of the power cord to the AC power receptacle on the front of the
switch.
2. Plug the AC power cord into a power source such as a wall socket or power strip.
When you apply power, the Power LED on the switch front panel lights.
if the Power LED does not light, check that the power cord is plugged in correctly
and that the power source is good.

Step 9: Manage the switch

The switch contains built-in web browser–accessible software for viewing, changing,
and monitoring the way it functions. This management software is not required for the
switch to work. You can use the ports without using the management software. However,
the management software enables the setup of VLAN and trunking features and also
Installation
Model GS418TPP
26 Hardware Installation Guide