Optional Step 5: Install An Sfp Transceiver Module; Step 6: Connect Devices To The Switch - NETGEAR GS110TUP Hardware Installation Manual

10-Port Gigabit Ethernet Ultra60 PoE++ Smart Managed Pro Desktop and Rackmount Switches
Optional Step 5: Install an SFP transceiver
module
The following optional procedure describes how to install an optional SFP transceiver
module into the SFP uplink port (10). For information about SFP transceiver modules,
see SFP uplink port for fiber connectivity on page 18.
Note: Contact your NETGEAR sales office to purchase these modules. If you do not
want to install an SFP module, skip this procedure.
To install an SFP transceiver module:
1. Insert the transceiver into the SFP uplink port.
2. Press firmly on the flange of the module to seat it securely into the connector.
The following figure shows model GS710TUP. Model GS110TUP provides the same
SFP uplink port.

Step 6: Connect devices to the switch

You can connect the following devices:
• Model GS110TUP. Connect PoE++, PoE+, PoE, and non-PoE devices to ports 1–4
and PoE+, PoE, and non-PoE devices to ports 5–8.
Connect either port 9 with an Ethernet cable to your network or port 10 with an SFP
transceiver module and cable to your network. (For information about the SFP
transceiver module, see Optional Step 5: Install an SFP transceiver module on page
Installation 37 Hardware Installation Guide