Install The Bulkhead Adapter Cable - Raven SmarTrax Installation Manual

Select a suitable location for the foot switch (P/N 063-0172-470) to be installed.
1.
Note:
The foot switch should be installed in a location where the operator has easy access to it and is
able to fully press the pedal.
Using the holes in the foot switch as a template, drill holes in the floor of the cab.
2.
Secure the foot switch to the floor by installing the supplied screws in each of the mounting holes.
3.
Locate the ENABLE connector on the node harness and connect it to the foot switch cable connector.
4.

Install the Bulkhead Adapter Cable

Bulkhead Adapter Cable Connected to Node Harness
FIGURE 4.
Connect the 12-pin connector of the bulkhead adapter cable (P/N 115-4001-176) to the mating 12-pin
1.
connector of the node harness (P/N 115-4001-109).
Back Access Panel Removed
FIGURE 5.
Remove the back access panel behind the operator's seat.
2.
Manual No. 016-5032-023 Rev. A
Cab Component Installation
31