Chapter 5
Fuse Compartment Access Panel Removed
FIGURE 6.
Remove the fuse compartment access panel to the right of the operator's seat.
3.
Bulkhead Connection Routed out of Instructional Seat
FIGURE 7.
Route the other bulkhead adapter cable connector out of the instructional seat, behind the operator's seat,
4.
and to the fuse panel via the exposed access panels.
Route the cable connector into the fuse compartment located in the right-rear corner of the cab.
5.
Drill a 1-3/4" hole in the cab near the right electrical panel.
6.
Install the bulkhead adapter cable connector into the drilled hole and secure it using the supplied lock
7.
washer and nut.
32
Case IH 2X44, 2X66, 2X77, and 2X88 Series Combines SmarTrax™ Installation Manual