Raven SmarTrax Installation Manual page 32

Chapter 4
Rod-End of WAS Installed on Rod-End of Steering Cylinder
FIGURE 7.
Secure the rod-end of the WAS on the WAS rod mounting bracket assembly using one M10 x 1.5 lock nut
20.
(P/N 312-4000-208).
Important:
Verify that the WAS cannot be overextended or compressed when the wheels are turned to their
extremes. Also verify that the sensor moves freely and is not being damaged within its range of motion.
Tighten the nuts on each end of the WAS to ensure it is securely installed.
21.
Route the cable from the base-end of the WAS along the machine's frame so that it is not near moving parts
22.
or heat sources. Secure with plastic cable ties as necessary.
28 Case IH 2X44, 2X66, 2X77, and 2X88 Series Combines SmarTrax™ Installation Manual