Table of Contents
Advertisement
21. From the exterior cab access panel, remove the four screws securing the existing 12-pin Deutsch bulkhead in
place. Keep hardware for use later in the procedure.
FIGURE 6. Existing Bulkhead Connection
Norac Cable
(Optional)
SmarTrax Node
12-pin
Bulkhead
22.Remove the bulkhead connector and cable (P/N 115-0172-087) from the machine and set it aside.
23.Locate the 12-pin bulkhead on the chassis cable (P/N 115-7303-102) that was connected to the ring terminals
and console cable earlier.
24.Place the 12-pin bulkhead into the hole the existing 12-pin bulkhead was previously removed from.
25. Secure the 12-pin bulkhead using the hardware retained in step 21.
SMARTRAX NODE CABLE INSTALLATION
1. Locate the existing SmarTrax node and harness (P/N 115-4001-169) (refer to Figure 6 on page 23).
2. Disconnect the harness from the node and all other connections.
3. Connect the provided SmarTrax cable harness (P/N 115-4001-229) to the SmarTrax node, console cable, and
other connections from step 2.
NORAC ADAPTER CABLE INSTALLATION (OPTIONAL)
To control the Norac boom leveling system through the Viper 4, order the Norac to Hagie ISO Adapter Cable (P/
N 115-0172-382) and install by:
1. Connect the round connector on the Norac to Hagie adapter cable to the mating connector of the console
cable.
2. Connect the other end of the Norac to Hagie adapter cable to the Norac control device as shown in Figure 6
on page 23.
P/N 016-0171-635 Rev. C
CAB PREPARATION AND WIRING
23
Advertisement
Table of Contents
