Install The Valve Harness Cable - Raven RS1 Guidance And Steering Installation Manual

2. Locate and disconnect the machine's seat switch harness connections.
3. Connect the SEAT SWITCH harness connections of the HDU switch harness cable between the machine's seat
switch connections.
4. Plug the ENABLE connector on the HDU switch harness cable to the machine's mating "X-708""REMOTE
ENGAGE SWITCH" located in the rear of the cab.
FIGURE 10. Master Switch Installation Location
5. Locate an unused switch port of the machine's control console.
6. Use a flat-head screwdriver to gently remove the cover of the unused switch port.
7. Route the MASTER connector on the HDU switch harness cable to the unused port.
8. Pull the MASTER connector through the switch port opening.
FIGURE 11. Master Switch Installed
9. Install the master switch (P/N 063-0173-961) on the MASTER connector of the HDU switch harness cable (P/N
115-4010-059).
10. Feed the harness and switch wires back into the console casing.
11. Press on the switch casing to ensure the switch is securely installed.

INSTALL THE VALVE HARNESS CABLE

NOTE: Hydraulic hose connection location may differ from the images in this manual.
P/N 016-5032-121 Rev. A
CAB COMPONENT INSTALLATION
25