Install The Accuboom Harness Cable; Install The Power Connection - Raven AccuBoom Installation Manual

Chapter 3
Note:
Mount the node so that the diagnostic lights face toward the front of the machine and the node
connector ports face down.

Install the AccuBoom Harness Cable

Install the Power Connection

CAN/Power Harness (P/N 115-1001-041) Connection (Under Catwalk)
FIGURE 2.
Locate or install the CAN/Power extension harness cable.
1.
Note:
The CAN/Power extension harness cable (P/N 115-1001-041) may be present if the machine is
already equipped with the AutoBoom system. If it is not, refer to the mounting instructions in the
7460/7660 SpraCoupe AccuBoom/AutoBoom Power Cable/Node Mounting Kit Installation
Procedure (P/N 016-0171-396) included in the node mounting kit (P/N 117-0171-342) to install it.
Locate the 4-pin Deutsch connector labeled "Logic/HC Power" on the AccuBoom harness cable and
2.
remove the dust cap.
Connect the Logic/HC Power connector to the CAN/Power extension harness cable.
3.
Locate the CAN terminator on the CAN/Power extension harness or the previously installed AutoBoom
4.
harness cable (if applicable).
Remove the CAN terminator and connect it to the connector labeled "CAN Bus" on the AccuBoom harness
5.
cable (P/N 115-1001-040).
Connect the AccuBoom harness to the connector from which the CAN terminator was previously removed.
6.
8 SpraCoupe 7460/7660 AccuBoom Installation Manual