CHAPTER
4
FIRST TIME CONFIGURATION
NOTE:
Depending upon configuration settings and installed unlocks, the following steps may vary.
After installing the XRT system:
1. Park the machine on a level surface.
2. Select the Machine Make, Machine Model, and the Machine Configuration.
FIGURE 1. Machine Selection
3. Press Next.
4. Verify the number of height sensors installed on the booms and center rack. This will be three, five, or seven
sensors depending upon the number of sensors installed.
If there are no Height Sensors Detected, press
016-0235-010 Rev. B
C ALIBRATION
C H A P T E R 4
to re-detect the number of sensors.
15