Sensor Reading; Autoboom Xrt Operation On Raven Operating Software (Ros); Run Screen Operation - Raven New Holland AutoBoom XRT Calibration & Operation Manual

C 3
HAPTER

SENSOR READING

Sensor Height displays the height for each of the sensors. The number of sensors displayed will match the number
of sensors on the machine. The table below describes the Sensor Height reading in more detail.
TABLE 1. Sensor Reading States
Image
Sensor Working/Reading
Sensor Not Reading/
Malfunctioning
Sensor Offline/Disabled
AUTOBOOM XRT OPERATION ON RAVEN OPERATING SOFTWARE
(ROS)

RUN SCREEN OPERATION

FIGURE 5. Run Screen
ISO
AutoBoom
Widget
1. Press the desired boom on the XRT widget to enable or disable AutoBoom XRT.
2. Press and hold the desired widget to open additional boom information. Pressing and holding also allows the
user to turn on or off the master switch.
10
Status
Indicates the sensor is functioning properly and reading
the desired target.
If there is an X through the sensor, the sensor is not
reading a target or is malfunctioning.
If there isn't a number below the sensor location, the
sensor may be offline or was disabled by the user.
New Holland AutoBoom XRT Calibration & Operation Manual
Description