Raven New Holland AutoBoom XRT Calibration & Operation Manual page 42

C 5
HAPTER
FIGURE 21. AutoBoom Node Orientation
BOOM ANGLE CALIBRATION (LEFT AND RIGHT)
The Boom Angle Calibration button allows the user to recalibrate the boom tilt sensors. This correlates the tilt
sensor measurement to an angular boom position.
1. Set the booms parallel and under 8 ft. [2.4 m] from the ground.
2. Press Next.
FIGURE 22. Height Sensor Setup - Set Booms Parallel
3. Raise the left boom until there is at least a 40 in. [101.6 cm] change in height.
4. Press Next.
36 New Holland AutoBoom XRT Calibration & Operation Manual