Table of Contents
Advertisement
C
4
HAPTER
14. Move the booms to a typical spray position. The center rack should be well below the travel stops and the inner
booms unfolded.
15. Touch the Next button to continue the fold calibration.
FIGURE 6. Vertical Center Sensor Calibration - Set to Spray Position
16. Enter the Center Rack Width. The center rack width is measured from the left boom pivot point to the right
boom pivot point. The pivot point is where the boom rotates as it is raised/lowered. The pivot point is generally
a horizontal steel pin.
FIGURE 7. Center Rack Setup
17. Press Next.
18. Verify the IMU orientation on the machine matches the image on the IMU Orientation page. If needed, press
the rotate buttons on the right side of the tab to adjust the orientation.
18
New Holland AutoBoom XRT Calibration & Operation Manual
Advertisement
Table of Contents
