Table of Contents
Advertisement
FIGURE 8. IMU Orientation
19. If required, press the Location button to rotate the machine view on the ECU Orientation screen.
20. Press Next.
21. Verify the machine is parked on a level surface
FIGURE 9. Center Rack Angle Setup
22.Press Calibrate Center Rack Angle.
23.After center rack angle calibration is complete, press Next.
24.Enter the Z offset from the bottom of the spray tips to the bottom of the sensor lens for the identified sensor.
25. Enter the X offset from the boom pivot point (not the machine center line) to the sensor mounting location.
016-0235-010 Rev. B
CALIBRATION
19
Advertisement
Table of Contents
