Table of Contents
Advertisement
HEIGHT SENSOR CONFIGURATION
The Height Sensor Configuration page allows the user to change the sensor Offset, review software information,
or select Sensor Enable. This page also allows the user to swap the sensors by pressing the Sensor Swap button
and update sensor software by touching the Height Sensor Update button.
Offset X is the horizontal distance from the pivot point of that boom (near the Left or Right Shoulder). Offset Z is
the vertical distance between the spray tip and the lens of the height sensor. If the sensor is below the spray tip,
the Mount should be set to 'Below.'
FIGURE 8. Height Sensor Configuration
Sensor Swap
Select the different sensors shown on the sprayer boom to modify that sensors configuration.
016-0235-010 Rev. B
SETTINGS
Height Sensor
Update
27
Advertisement
Table of Contents
