Table of Contents
Advertisement
CHAPTER
3
CALIBRATION WIZARD
NOTE:
Complete the following calibration steps to setup an RCM Level 3 with dry manure or litter spreading
features.
1. Enter the profile name for the implement.
2. Select Pull-Behind Spreader from the drop down menu.
NOTE:
If the spreader box is installed on a truck chassis, select the "Self-Propelled Spreader" option for the
machine type.
3. Enter the application width of the spreader.
4. Select the Next button in the lower, right corner of the page to proceed.
FIGURE 1. Name Profile Page
5. The ECU number will remain at 1.
6. The Number of Products will also be set to 1.
7. Select the Next button in the lower, right of the page to proceed.
NOTE:
Select the Back button in the lower, left corner of the page to return to the previous page if needed.
Calibration: Calibration Wizard
C ALIBRATION
C H A P T E R 3
9
Advertisement
Table of Contents
