Table of Contents
Advertisement
AUTOFOLD CALIBRATION
AutoFold Calibration recalibrates the sensors used for performing automatic folding operations. This should be
performed if sensors have been adjusted/replaced, or if AutoFold is not completing an AutoFold IN or AutoFold
OUT sequence.
1. Fold the boom and lower the booms completely into the cradle.
FIGURE 27. Set Folded Position
2. Raise the booms above the cradle. This should be mid-way between the height that clears the cradle lip and
the maximum allowed height when the booms return to the cradle. This is the height the boom will move to
when returning to the cradle.
FIGURE 28. Raise Above Cradle
016-0235-010 Rev. B
SETTINGS
39
Advertisement
Table of Contents
