Table of Contents
Advertisement
FIGURE 23. Height Sensor Setup - Raise Left Boom
5. Raise the right boom until there is at least a 40 in. [101.6 cm] change in height.
6. Press Next.
FIGURE 24. Height Sensor Setup - Raise Right Boom
AUTOBOOM FOLD CALIBRATION
The AutoBoom Fold Calibration allows the user to update the primary boom fold (Yaw) sensor calibration. These
sensors are used to prevent the Master Switch from being turned on if the booms are not unfolded.
1. Fold the boom in so the booms are stored in the transport position.
2. Touch the Next button to continue fold calibration.
016-0235-010 Rev. B
SETTINGS
37
Advertisement
Table of Contents
