GE Moisture Image 1 Series Programming Manual page 42

Hygrometer
Hide thumbs Also See for Moisture Image 1 Series:
Table of Contents

Advertisement

Entering Moisture
Reference Values (cont.)
Basic Programming
HIGH
3. Move the pointer to
[YES].
4. Enter the high reference value for that channel and press [YES].
5. The pointer automatically moves to
Press [YES].
6. Enter the low reference value for that channel, and press [YES].
7. Repeat steps 3 through 6 to enter the high and low reference
values for the remaining channels.
Note: You may also enter the Auto-Cal Interval while in the
Reference Menu. Simply press the INTERVAL menu key and
enter the desired interval. See page 3-7 for more information.
To enter reference values for oxygen cell and pressure inputs, refer to
the following sections. To exit, press the DONE menu key until Main
Menu appears on the message line. Then refer to Displaying
Measurements on page 2-28. When you exit, the Series 1
automatically calibrates each channel.
for the desired channel, and press
LOW
for the same channel.
April 2004
2-23

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Moisture Image 1 Series and is the answer not in the manual?

This manual is also suitable for:

Mis 1

Table of Contents