Open The Meter Display Window - GE Moisture Image 1 Series Programming Manual

April 2004
Open the Meter Display
Window
4-2
1. From the "File" menu, click on the "New Meter Browser" option.
2. From the network tree, click on the desired communications port
(COM 1, etc.) and meter.
3. From the expanded tree, click on the "Display" option. A list of
six display pages appears. Clicking on any page opens the list of
channels, modes (temperature, hygrometry, oxygen, etc.) and
display units currently assigned for that page.
4. Double-clicking on any page opens the "Meter Display" window,
shown in Figure 4-1 on page 4-3. Each individual blue window
shows the mode and unit measured in the corresponding window
on the Series 1 page, with the assigned channel number in the
upper left corner. A line below indicates which page the meter is
currently displaying.
5. To scroll to a particular page, click on the left or right pointer
buttons at the bottom of the window.
6. If you want to set a particular page as the page currently displayed
on the meter, scroll to that page and click on
Note: While each window shows the sensor and units measured, you
must click on the "Text Display" option from the "Output"
menu, or view the Series 1 screen, to see the actual
measurements at any given time.
[Set Active Page]
Programming with PanaView
.