8.5
8.5.5 Setting DGPS / Checking DGPS Receiving Status
8.5.5.1 Setting DGPS
Setting the beacon receiver is required for accurate measurement using the DGPS.
•
Setting
Mode:
Manual = Set the frequency and baud rate of the beacon receiver. This mode enables quick
DGPS receiving. Beacon cannot be received, however, when the own ship is outside
the transmission area of the beacon receiver.
Auto
= Automatically searches the beacon transmitting station and receives beacon. In
this mode, however, a longer time is required for searching.
1. Press the
Procedures
2. Press the
3. Press the
4. Press the
5. Press the
6. Press the
7. In the AUTO mode
Set the search step at 1 kHz for JAPAN.
After pressing the
1 kHz , and press the
In the MANUAL mode
Transmission starts after the frequency and baud rate of the beacon transmitting station
inside the receiving area are set.
•
After pressing the
(
follows.
Daio-saki: 288 kHz , Tsurugi-saki: 309 kHz
•
After pressing the
move the underline to the baud rate at 200 bauds for Japan and press the
key to set it.
8. After entering the setting, press the
SUB
key to open the SUB MENU.
MENU
9
key twice to open the INIT SET #2 menu.
8
key to open the SETTING DGPS/DGPS STATUS menu.
1
key to select "MODE".
1
key to select "AUTO" or "MANUAL".
ENT
key to confirm the setting.
4
key to select "SET DATA", press the
ENT
key.
2
key to select "FREQUENCY", press the numeric key
ENT
9
0
to
) and
3
key to select "BAUD RATE", press the
8 – 41
key to select frequency. The frequency is as
5
key to select "SEND DATA".
4
key to select
3
key to
ENT