Control Menu - Lightware HDMI-TPS-TX210 User Manual

   
5.SoftwareControl-LightwareDeviceController
5.9. Control Menu
5.9.1. RS-232
Alltheserialsettingsavailableinthismenu,includingtheoperationmodesetting;seemoreinformationin
the SerialInterface section. #rs232 #rs-232 #serial

ATTENTION! TheRS-232Operation modeismirroredontheLocalandLinkserialport.Theothersettings
canbeadjustedseparatelyonthetwoports.
RS-232 Tab in the Control menu
HDMI-TPS-TX200series–User'sManual
Settings
Thefollowingsettingsandfunctionsareavailable:
RS-232mode;
▪
▪ Baudrate;
▪ Databits;
Parity;
▪
▪ Stopbits;
SeemoredetailsintheRS-232Modes
Command Injection
Inthismode,thetransmitterworksasanRS-232bidirectionalconverter.Tousethismode,enabletheoption
andsettheRS-232modetoCommandInjection.
Control Protocol
The serial command interpreter can accept only one set of commands, therefore, the desired protocol must
beset:
▪ LW2:LW2protocolcommandsareaccepted,seetheLW2Programmer'sReference
▪
LW3:LW3protocolcommandsareaccepted,seetheLW3Programmer'sReference
Send Message
The message in the field can be sent out via the current RS-232 port. Response cannot be seen in the
surface.
ATTENTION!

commandisanLW3messageithastobeclosedbyCarriagereturnandLinefeed,e.g:CALL/MEDIA/
VIDEO/XP:switch(I1:O1)\x0d\x0a.
Appliedfirmwarepackage:v1.2.0 | LDCsoftware:v2.2.0
section.
Theescapingisdoneautomaticallywhensendingamessageviathissurface.Whenthe
#message
#commandinjection
chapter.
chapter.
42