Lightware HDMI-TPS-TX210 User Manual page 49

   
5.SoftwareControl-LightwareDeviceController
RS-232 Settings
Makesurethattheseriallineisestablishedbetweenthetransmitterandtheprojector.CheckthattheRS-
232settingsofthetransmitterissetexactlythesamewhichrequiredfortheprojector:baudrate,databits,
parity,stopbits.Thetransmitterneedstobesetto:Controlprotocol:LW3;andRS-232mode:Pass-through.
SeetherelevantLDCsettingsintheRS-232
Setting the Event
YoucancreatetheEventintheWizardinfewsimplesteps:
Step 1. Setthecondition.
Selecttherequiredparameterstosetthecondition:
▪
Category:Video;
▪ Expression:Signalisdetectedonaport;
▪
Port:O1.
Click on the Applybuttontocompletetheprocedure.Whenitisdone,theconditionappearsontheupperside
intextualandLW3commandformataswell.
Step 2. Settheaction.
Iftheconditionisfulfilled,thefollowingactionneedstobelaunched:thereceiversendsacommandtothe
projectorovertheserialline:
▪
Power on-therequiredcommandwhichisacceptedbytheprojector:PWR0<CR><LF>
Forthisinstancethecommandhastobeclosedwiththe<CR><LF>characterssotheyneedtobeescaped.
Youcanusethefollowingformatforescaping:
<command
Inthecurrentcasethecommandis:PWR0\x0d\x0a
section.
><\x0d\x0a><command ><\x0d\x0a>...
1 2
...<command ><\x0d\x0a>
n
Appliedfirmwarepackage:v1.2.0 | LDCsoftware:v2.2.0
HDMI-TPS-TX200series–User'sManual
Selecttherequiredparameterstosettheaction:
▪
Category:RS-232;
▪ Expression:SendRS-232message;
▪ Port:P1;
▪
Message:PWR0\x0d\x0a
Step 3. Enable the Event.
SelecttheE1 enabled pipe in upper left corner to set the Event as launched.

INFO: Ifyoudonotfindtherequiredcategory/expression/etcwhatyouneed,choosetheAdvancedmode
intheWizardwheretheentireLW3structuretreeisavailable.Forexampleinsteadofsignaldetectionyou
cansetaspecifiedresolutionorcolorrangeeitherasacondition.
49