Port Configuration; Protocolsetting; Baud Rate Setting; Databitsetting - Lightware HDMI-TPS-TX210 User Manual

   
7.LW3Programmer'sReference
7.8. RS-232 Port Configuration
ATTENTION!
BelowlistedcommandscanbeusedtosettheRS-232portparameters.Toquerythecurrent
valueofaparameterusetheGETcommand,e.g.:GET /MEDIA/UART/P1.BaudRate.
ATTENTION!
TheRS-232Operation modeismirroredontheLocalandLinkserialport.Theothersettings
canbeadjustedseparatelyonthetwoports(P1andP2).
INFO:
RS-232portnumberingcanbefoundinthe
7.8.1. Protocol Setting
Command and Response #protocol
SET·/MEDIA/UART/<port>.ControlProtocol=<protocol>

pw·/MEDIA/UART/<port>.ControlProtocol=<protocol>

Parameters
If the <protocol> parameter is 0 the device is set to receive LW2 commands. If the value is 1 the device is set
to receive LW3 commands.
Example
 SET/MEDIA/UART/P1.ControlProtocol=1
 pw/MEDIA/UART/P1.ControlProtocol=1
7.8.2. BAUD Rate Setting
Command and Response
SET·/MEDIA/UART/<port>.BaudRate=<baud_rate>

pw·/MEDIA/UART/<port>.BaudRate=<baud_rate>

Parameters
Identifier Parameterdescription
<baud_rate> The Baud rate of the serial port.
Example
 SET/MEDIA/UART/P1.BaudRate=6
 pw/MEDIA/UART/P1.BaudRate=6
PortNumbering section.
#rs232 #rs-232 #serial
Parametervalues
0:4800,1:7200,2:9600,3:14400,4:19200.5:38400,
6:57600,7:115200
Appliedfirmwarepackage:v1.2.0 | LDCsoftware:v2.2.0
HDMI-TPS-TX200series–User'sManual
7.8.3. Databit Setting
Command and Response
SET·/MEDIA/UART/<port>.DataBits=<data_bits>

pw·/MEDIA/UART/<port>.DataBits=<data_bits>

Parameters
The <data_bits> parameter can be 8 or 9.
Example
 SET/MEDIA/UART/P1.DataBits=8
 pw/MEDIA/UART/P1.DataBits=8
7.8.4. Stopbit Setting
Command and Response
SET·/MEDIA/UART/<port>.StopBits=<stop_bits>

pw·/MEDIA/UART/<port>.StopBits=<stop_bits>

Parameters
Identifier
<stop_bits>
Example
 SET/MEDIA/UART/P1.StopBits=0
 pw/MEDIA/UART/P1.StopBits=0
7.8.5. Parity Setting
Command and Response
SET·/MEDIA/UART/<port>.Parity=<parity_value>

pw·/MEDIA/UART/<port>.Parity=<parity_value>

Parameters
Identifier
<parity_value>
Example
 SET/MEDIA/UART/P1.Parity=0
 pw/MEDIA/UART/P1.Parity=0
Parameterdescription Parametervalues
Stopbitvalue
0:1;1:1.5;2:2
Parameterdescription Parametervalues
Paritysetting
0:noparity;1:odd;2:even
83