Viewing Wls Measurement Results - Keysight X Series Manual

Making WLAN Measurements
Making WLAN List Sequence (WLS) Measurements
Step 6. Get the results:
Table 2-6 SCPI Commands for WLS Measurement (5)
READ:WLS1?
DISP:WLS:VIEW RES

Viewing WLS Measurement Results

To view the measurement results, press View/Display, Result Metrics. This
view provides a list of measurement results with Pass or Fail indicator
highlighted in green or in red, respectively. You can use the DOWN/UP key to
scroll the list by using either the front panel or the key board.
Figure 2-30 WLS (Result Metrics View)
Pressing View/Display, Parameter List, you can see the available SCPI
commands listed alphabetically for this measurement. You can verify and
change values with DOWN/UP key from either the front panel or key board.
Keysight WLAN Measurement Guide
SCPI Commands Notes
After this command is sent to the analyzer, all
results are returned.
For more information on results returned, see
N9077A & W9077A WLAN Measurement
Application User's and Programmer's Reference.
All measurement results are displayed in the
Result Metrics View with Pass/Fail indicator.
71