Measurement Example Signal Settings; Measurement Procedure - Keysight X Series Manual

Making WLAN Measurements
Making Monitor Spectrum Measurements

Measurement Example Signal Settings

Measurement Procedure

Step
1. Select WLAN Mode.
2. Preset the analyzer.
3. Select the desired radio
standard.
4. If necessary, select the
frequency settings.
5. Select the measurement.
6. Examine the keys that are
available to change
measurement parameters
from their default
conditions.
7. Select the monitor
spectrum measurement
again or restart the
measurement.
Keysight WLAN Measurement Guide
Frequency: 2412 MHz
Output Power: -30 dBm (at analyzer input)
WLAN signal radio standard: 802.11n/40 MHz
Data Rate: 270 Mbps 64 QAM
Action
MODE WLAN
a. Press ,
Mode Preset
a. Press
factory preset.
b. To recall a user-defined Preset:
User Preset
Press
preset the current mode.
MODE Setup
Press
802.11n 802.11n (40 MHz)
,
FREQ Channel
a. Press
MEAS Monitor Spectrum
a. Press ,
Meas Setup,
a. Press
parameters you want to change and
input your settings.
Meas, Monitor Spectrum
a. Press
Restart
or press
Notes
.
button for the
User Preset
, to
Rad io Std
, ,
.
2412 MHz
, , .
The default display shows the
.
Current (yellow trace) data. To
make viewing the display easier,
you can view either the Current
trace or Average separately.
then select the
,
.
79