Making WLAN Measurements
Making Spectrum Emission Mask Measurements
Example of One-Button-Measurement - Spectrum Emission Mask
This example assumes the signal is correctly applied to the input.
Step 1. Press Mode Preset
Step 2. Press Meas, Spectrum Emission Mask
Step 3. View the measurement default view. (See
Figure 2-12
Spectrum Emission Mask (Default View)
If you have a problem, and get an error message, see Instrument Messages.
Example of Using SCPI Commands
Select WLAN mode
Select the Spectrum Emission Mask measurement
Get the 14 comma-separated pass/fail test results (0=passed, 1=failed)
determined by testing the minimum margin point from the limit line.
Keysight WLAN Measurement Guide
INST WLAN
CONF:SEM
READ:SEM[7]?
Figure
2-12).
39