Yvib Compatibility; Yvib Version Compatibility; Yvib Terminal Board Compatibility - GE Mark VIeS System Manual

8.2.1 YVIB Compatibility

The YVIB I/O pack contains an internal processor board. The following table lists the available versions of the YVIB.
I/O Pack Processor
Board †
YVIBS1B BPPC
† Internal to the I/O pack and are not replaceable.
‡ YVIBS1B supports an additional KeyPhasor* input, a CDM input, and other enhanced processing capabilities.
Attention
Attention
The YVIB I/O pack is compatible with the Vibration (TVBA) terminal board.
Terminal Board
TVBAS2B
Note Refer to the section TVBA Compatibility
I/O pack redundancy refers to the number of I/O packs used in a signal path, as follows:
• Simplex uses one I/O pack.
• TMR uses three I/O packs.
YVIB Vibration Monitor Modules

YVIB Version Compatibility

Application Compatible
Board † (Supported)
Firmware
BBAA V05.01 and later Supported in
YVIBS1B cannot be mixed on a TMR module.
If upgrading to YVIBS1B with an existing YVIBS1A configuration, use the ToolboxST
application to correct the GAP12 configuration. Refer to the replacement procedure
To replace a YVIB I/O pack
After upgrading existing YVIBS1A applications to YVIBS1B, the user may need to
use the configurable low-pass filter to roll-off responses to match existing
peak-to-peak calculations. This is because the YVIBS1B has an increased input signal
bandwidth of 4500 Hz.

YVIB Terminal Board Compatibility

Description
Safety vibration terminal board with buffered outputs;
N28 function integrated into terminal board and YVIB
S-position is lined up vertically with R and T positions.
for additional information.
Public Information
ControlST Enhanced
Versions Signal Mode
Yes
V06.02 and later
in the section YVIB I/O Pack Replacement.
GEH-6855_Vol_II System Guide 229
Channels Sensor
‡ Types
13 Refer to the table
YVIB Supported
Sensor Inputs.
I/O Pack Redundancy
Simplex
Dual TMR
Yes No Yes