Entering Energy Saving Mode; Exiting Energy Saving Mode; Selecting The Energy Saving Mode Type - Ricoh FAX2900L Operator's Manual

SMTEN990427_FM.book Page 95 Thursday, September 2, 1999 10:03 AM
When you load paper in Energy Saving mode, no error will be displayed even
if the cassette is not pushed right in. After loading paper, press the Energy
Saver key and check that "READY" is shown on the display.
The Manual Receive indicator goes out in Energy Saving mode even if Man-
ual Receive is turned on.
Even though the operation panel display goes out in Energy Saving mode, in-
dicators that flash or light during communication or reception still work.
When the Receive File indicator lights, exit Energy Saving mode and take ap-
propriate action.

Entering Energy Saving mode

The machine enters Energy Saving mode when:
• Nobody uses the machine for about 5 minutes (it automatically enters Energy
Saving mode).
• The user holds down the Energy Saver key for about 2 seconds.
Note
If you want to change the five minute period to one or three minutes, or if you
do not want your machine to enter the Energy Saving mode automatically,
please contact your service representative.
Energy Saving mode cannot be entered when a document is set.

Exiting Energy Saving mode

Your machine exits Energy Saving mode when a fax is received.
To exit Energy Saving mode manually:
• In Energy Saving Standby mode, press the Energy Saver key.
• In Fax Standby mode, press any key.
• Set a document.
• Pick up the optional handset or the external telephone handset.

Selecting the Energy Saving mode type

To select the Energy Saving mode type, adjust the bit switch below with the User
Parameters. (See P.166 "User Parameters".)
Switch 05 bit 6
• Energy Saving Standby: To let the heating roller cool to room temperature,
set bit 6 to 0.
• Fax Standby: To let the heating roller cool halfway set bit 6 to 1.
Energy Saving
5
95