Dtc Clearance; Scan Tool Data - Suzuki GRAND VITARA JB416 Service Manual

DTC Clearance

WARNING
!
When performing a driving test, select a safe
place where there is neither any traffic nor
any traffic accident possibility and be very
careful during testing to avoid occurrence of
an accident.
After repair or replace malfunction part(s), clear all DTCs
by performing the following procedure or using SUZUKI
scan tool.
1) Connect SUZUKI scan tool to data link connector in
the same manner as when making this connection
for DTC check.
2) Turn ignition switch to ON position.
3) Erase DTC according to instructions displayed on
scan tool. Refer to scan tool operator's manual for
further derails.
NOTE
For DTC C 1021, C1022, C1025, C1026, C1031,
C1032, C1035, C1036 and C1061, confirm that
ABS warning lamp turns off after performing
Step 2 of "Test Driving" under "ABS Check:
", and then clear the DTCs.
4) After completing the clearance, turn ignition switch
OFF and disconnect scan tool from data link
connector.
5) Perform "Driving Test" (Step 2 of "ABS Check: ") and
"DTC Check: " and confirm that NO DTC is displayed
on scan tool.

Scan Tool Data

The parameter data below are values measured with the
scan tool when the normally operating vehicle is under
the following conditions. When taking measurements for
comparison by using the scan tool, be sure to check that
the vehicle is under the following conditions.
• Apply parking brake and block wheels.
• Ignition switch ON.
• Turn OFF air conditioner (if equipped).
• Apply no load to power steering (if equipped). (Don't
turn it)
• Turn OFF all electric loads (except ignition).
• No DTC.
• ABS is not operated. (Normal braking operation)
Scan Tool
S5JB0E4504006
Data
Battery
Voltage
Pump Motor
Driver
RF Wheel
Speed
LF Wheel
Speed
RR Wheel
Speed
LR Wheel
Speed
Brake Switch
G sensor
Scan Tool Data Definition
Battery Volt (V): Battery Voltage is an analog input
signal read by the ABS (ESP®) control module.
Certain ABS (ESP®) control module functions will be
modified if the battery voltage falls below or rises
above programmed thresholds.
Pump Motor Driver (V): This parameter indicates the
operational condition of the pump motor driver
(transistor).
RF Wheel Speed, LF Wheel Speed, RR Wheel Speed
and LF Wheel Speed (km/h, MPH): Wheel speed
is an ABS (ESP®) control module internal
parameter. It is computed by reference pulses from
the wheel speed sensor.
Brake Switch (ON, OFF): This switch signal informs
the ABS (ESP®) control module whether the brake
is active or not.
S5JB0E4504007
G Sensor (G): The G-Sensor converts gravity during
the vehicle acceleration / deceleration in to a voltage
conditions and controls the ABS for 4WD vehicle.
(without ESP®)
Vehicle acceleration is measured by yaw rate / G
sensor assembly and output to ESP® control
module by pulse signal for 4WD vehicle. (with
ESP®)
Standards Condition
10.0 – 16.0 V
0.0 V
0 km/h, 0.0 MPH Vehicle stop
0 km/h, 0.0 MPH Vehicle stop
0 km/h, 0.0 MPH Vehicle stop
0 km/h, 0.0 MPH Vehicle stop
Brake pedal
ON
depressed
OFF Brake pedal released
Place vehicle on the
0 ± 0.09G
level
ABS: 4E-12
—
—