Suzuki GRAND VITARA JB416 Service Manual page 184

3C-67 Transfer: Motor-Shift Type (Transfer with Shift Actuator)
21) Clean mating surface of oil pump cover (1) and rear
case (2), apply sealant to rear case as shown in
figure by such amount that its section is 1.2 mm
(0.047 in.) in diameter, mate oil pump cover with rear
case and then tighten bolts (3) to specified torque.
"A": Sealant 99000–31260 (SUZUKI Bond
No.1217G)
Tightening torque
Oil pump cover bolt (a): 23 N·m (2.3 kgf-m, 17.0
lb-ft)
1
22) Clean mating surface of control cover (1) and center
case (2), apply sealant to center case as shown in
figure by such amount that its section is 1.2 mm
(0.047 in.) in diameter, confirm the each fork of
control cover is in groove of the sleeve, mate control
cover with center case and then tighten control cover
bolts (3) to which thread lock cement has been
applied and control cover dowel bolts (4) to specified
torque.
"A": Sealant 99000–31260 (SUZUKI Bond
No.1217G)
"B": Thread lock cement 99000–32110 (Thread
Lock Cement Super 1322)
Tightening torque
Control cover bolt (a): 23 N·m (2.3 kgf-m, 17.0 lb-
ft)
Control cover dowel bolt (b): 23 N·m (2.3 kgf-m,
17.0 lb-ft)
"A"
2
3, (a)
3, (a)
I5JB0A331049-02
1
3, "B", (a)
23) Install center differential lock switch (1), 4L/N switch
(2) and breather pipe (3).
Tightening torque
Center differential lock switch (a): 20 N·m (2.0
kgf-m, 14.5 lb-ft)
4L/N switch (b): 20 N·m (2.0 kgf-m, 14.5 lb-ft)
1, (a)
24) Install harness bracket (1).
Tightening torque
Harness bracket bolt (a): 10 N·m (1.0 kgf-m, 7.5
lb-ft)
(a)
1
"A"
2
3, "B", (a)
4, "B", (b)
3, "B", (a)
I5JB0A331051-04
3
2, (b)
I5JB0A331052-02
(a)
1
I5JB0A331053-01