2B-10 Front Suspension:
4) Remove caliper (1) with carrier.
NOTE
Hang removed caliper with a wire hook or the
like (3) so as to prevent brake hose (4) from
bending, twisting or tension.Do not depress
brake pedal during pads removal.
Do not operate brake pedal with pads
removed.
5) Pull brake disc (2) off by using two 8 mm bolts.
6) Remove wheel hub housing bolts (3), and then
remove wheel hub assembly (1) and dust cover (2).
3
7) Remove hub bolts (1) with copper hammer or
hydraulic press.
CAUTION
!
Never remove bolt unless replacement is
necessary.
Be sure to use a new bolt for replacement.
Installation
1) Insert new hub bolt (1) in hub hole. Rotate hub bolt
2) Apply grease to end face of inner ring (2) before front
I5JB0A220014-01
2
3
1
I5JB0A220015-01
3) Install wheel hub (1) and dust cover (2) to steering
4) Tighten wheel hub housing bolts (3) to specified
1
I5JB0A220016-01
slowly to assure that serrations are aligned with
those made by original bolt.
1
wheel nub (1) installation.
CAUTION
!
Do not apply the grease to the encoder
section to avoid the encoder malfunction.
"A": Grease 99000–25010 (SUZUKI Super
Grease A)
1
knuckle.
torque
Tightening torque
Wheel hub housing bolt (a): 50 N·m (5.0 kgf-m,
36.5 lb-ft)
3,(a)
I5JB0A220017-01
2, "A"
I5JB0A220018-01
2
3,(a)
1
I5JB0A220019-01