Suzuki GRAND VITARA JB416 Service Manual page 234

4E-11 ABS:
DTC Check
1) Turn ignition switch to OFF position.
2) Connect SUZUKI scan tool to data link connector
(1).
Special tool
(A): SUZUKI scan tool
(A)
3) Turn ignition switch to ON position.
4) Read DTC according to instructions displayed on
SUZUKI scan tool and print it or write it down. Refer
to SUZUKI scan tool operator's manual for further
details.
NOTE
If SUZUKI scan tool can not communicate
ABS (ESP®) hydraulic unit / control module,
perform "Serial Data Link Circuit Check: ".
5) After completing the check, turn ignition switch off
and disconnect SUZUKI scan tool from DLC.
DTC Table
S5JB0E4504004
Be sure to perform "ABS Check: " before
starting diagnosis.
DTC (displayed on
SUZUKI scan tool)
1
I5JB0A450008-01
CAUTION
!
NO DTC Normal
G sensor circuit failure (for 4WD
C1015
vehicle)
C1021 RF
C1025 LF
Wheel speed sensor circuit
C1031 RR
C1035 LR
C1022 RF
C1026 LF Wheel speed sensor or
C1032 RR encoder failure
C1036 LR
Inlet solenoid valve circuit
C1041
failure
RF
Outlet solenoid valve circuit
C1042
failure
Inlet solenoid valve circuit
C1045
failure
LF
Outlet solenoid valve circuit
C1046
failure
Inlet solenoid valve circuit
C1051
failure
RR
Outlet solenoid valve circuit
C1052
failure
Inlet solenoid valve circuit
C1055
failure
LR
Outlet solenoid valve circuit
C1056
failure
ABS (ESP®) control module power
C1057
supply circuit failure
Pump motor and/or motor driver
C1061
circuit failure
Solenoid valve power supply driver
C1063
circuit failure
ABS (ESP®) control module
C1071
internal defect
Control Module Communication
U1073
Bus Off
Lost Communication with ECM
U1100
(Reception error)
S5JB0E4504005
Diagnostic Items