Esp® Warning Lamp Comes On Steady - Suzuki GRAND VITARA JB416 Service Manual

Step
5 1) Remove combination meter with ignition switch turned
OFF.
2) Check for proper connection to "PPL/RED" and "BLK"
wire of combination meter connector.
3) If OK, turn ON ignition switch and measure voltage at
"PPL/RED" wire of combination meter connector and
vehicle body ground.
Is it 10 – 14 V?
6 1) Measure resistance between "BLK" wire of combination
meter connector and vehicle body ground.
Is resistance less than 2
ESP® Warning Lamp Comes ON Steady
Wiring Diagram
Refer to "ESP® Warning Lamp Does Not Come ON at Ignition Switch ON: ".
Circuit Description
Operation (ON/OFF) of ESP® warning lamp is controlled by ESP® control module through lamp driver module in
combination meter.
If ESP® system is in good condition, ESP® control module turns ESP® warning lamp ON at the ignition switch ON,
keeps it ON for 2 seconds and then turns it OFF. If an abnormality in the system is detected, ESP® warning lamp is
turned ON continuously by ESP® control module. Also, it is turned ON continuously by lamp driver module when the
connector of ESP® control module is disconnected.
Troubleshooting
Step
1 1) Perform diagnostic trouble code check.
Is there any DTC(s)?
2 Are main fuses for ABS pump motor and ABS solenoid in
good condition?
3 1) Turn ignition switch to OFF.
2) Disconnect ESP® control module connector.
3) Check for proper connection to ESP® control module
connector at terminals "E53-35", "E53-16" and "E53-47".
4) If OK then turn ignition switch to ON position and
measure voltage between terminal "E53-35" and vehicle
body ground.
Is it 10 – 14 V?
4 1) Turn ignition switch to OFF position.
2) Check for proper connection to ESP® control module
connector at terminals "E53-1" and "E53-32".
3) If OK then turn ignition switch to ON position and
measure voltage between each terminal of "E53-1",
"E53-32" and vehicle body ground.
Are they 10 – 14 V?
5 1) Turn ignition switch to OFF and measure resistance
between each terminal of "E53-16", "E53-47" and vehicle
body ground.
Is resistance less than 2
Action
Ω
?
Action
Ω
?
Electronic Stability Program:
Yes
Go to Step 6.
Replace combination
meter.
Yes
Go to applicable DTC
diag. flow.
Go to Step 3.
Go to Step 4.
Go to Step 5.
Go to Step 6.
4F-22
No
Repair power supply
circuit for combination
meter.
"BLK" circuit open or
high resistance.
S5JB0E4604009
No
Go to Step 2.
Replace fuse and check
circuit for short to
ground.
"GRN/ORN" circuit
open.
"WHT/RED" and/or
"WHT/BLU" circuit
open.
Ground circuit for ESP®
control module open or
high resistance.