Suzuki GRAND VITARA JB416 Service Manual page 109

11) Remove front propeller shaft referring to "Propeller
Shaft Removal and Installation: in Section 3D in
related manual".
12) Fix radiator (2) to body with rope (1) to avoid the
radiator (2) fall off when front suspension frame
lowered.
2
13) Support engine assemble as follows.
• For using engine supporting device
Using engine supporting device, support engine
according to "Engine Supporting Points: in
Section 0A in related manual".
CAUTION
!
Be sure to support engine by using engine
front hunger only. Failure to follow this
instruction could result in damage to engine
front and rear hungers.
• For using chain hoist
a) Remove hood referring to "Hood Removal and
Installation: in Section 9J in related manual".
b) Support engine assemble by using chain hoist.
14) Support suspension frame at the specified positions
(1) indicated in figure.
WARNING
!
When removing suspension frame, be sure to
apply some supporting equipment under it at
well-balanced position as shown in the figure
section so as to prevent from its drop.
1
15) Remove engine front body side mounting nuts (1).
16) Remove suspension frame mounting bolts (2), and
then lower suspension frame (3) with stabilizer bar,
P/S gear box assembly and front differential
assembly.
1
I5JB0A220046-01
17) Remove P/S gear box assembly (1) and front
differential assembly (2) referring to "P/S Gear Case
Assembly Removal and Installation: in Section 6C in
related manual" and "Front Differential Dismounting
and Remounting: Front in Section 3B in related
manual".
1
I5JB0A220047-01
Front Suspension:
1
2
2
3
1
2
2B-17
I5JB0A220048-01
I5JB0A220049-01