Suzuki GRAND VITARA JB416 Service Manual page 427

Scan Tool Data Definitions
Vehicle Speed (km/h, mph): This parameter indicates the vehicle speed computed by ECM.
Outside air Temp (°C, °F): It is detected by outside air temperature sensor.
Battery Voltage (V): This parameter indicates battery positive voltage inputted to BCM.
Coolant Temp (Engine coolant temperature) (°C, °F): This parameter indicates the engine coolant temperature
computed by ECM.
Engine Speed (RPM): This parameter indicates the engine speed computed by ECM.
Fuel Consumption (km/l): This parameter indicates the fuel consumption computed by ECM.
Key Reminder Sw (Key reminder switch) (Pulled / Key in): This parameter indicates the state of the key reminder
switch.
Door key Sw (Door key cylinder switch) (Lock / Neutral / Unlock): This parameter indicates the state of the door
key cylinder switch.
Door lock Sw (Manual door lock switch) (Lock / Neutral / Unlock): This parameter indicates the state of the
manual door lock switch.
Driv Door Sw (Driver side door switch) (Open / Close): This parameter indicates the state of the driver side door
switch.
Pass Door Sw (Other than driver side door switch) (Open / Close): This parameter indicates the state of the door
switches other than driver side door switch.
Brake Fluid Level (Low / Normal): Low: Brake fluid level is lower than specified level.
Normal: Brake fluid level is higher than MIN level.
Parking Brake Sw (Parking brake switch) (ON / OFF): ON: Parking brake lever is pulled up.
OFF: Parking lever is released
Rear Defogger Sw (Rear end door window defogger switch) (ON / OFF): This parameter indicates the state of
the rear end door window defogger switch.
Tail Light Sw (Lighting switch) (ON / OFF): This parameter indicates the state of the lighting switch.
Driv Seat belt Sw (Driver seat belt switch) (Fasten / Unfasten): This parameter indicates the state of the driver
side seat belt buckle switch.
Charge Light (ON / OFF): This parameter indicates the state of the charge system monitor switch.
Oil pressure switch (ON / OFF): This parameter indicates the state of the oil pressure switch.
A/C Switch (ON / OFF): This parameter indicates the state of the air conditioning switch.
Rear Wiper Sw (Rear wiper switch) (ON / INT / OFF): This parameter indicates the state of the rear wiper switch.
Front Fog Light Sw (Front fog light switch) (ON / OFF): This parameter indicates the state of the front fog light
switch.
Headlight Sw (Headlight switch) (ON / OFF): This parameter indicates the state of the lighting switch.
Diagnosis Using Output Test Function of SUZUKI Scan Tool
SUZUKI scan tool has the output test function which can force operation of following actuators and relays of the
system controlled by BCM. When a malfunction is found in the system controlled by BCM, execute the output test
which enables easy judgment whether the malfunction is on the input side or output side of BCM. For detailed
information on operation of SUZUKI scan tool, refer to "SUZUKI Scan Tool Operator's Manual".
Output Test Item
Hazard Warning Light
Interior (Dome) Light
Parking/Tail Light
Front Fog Light
Rear defogger
D.R.L.
Auto on headlight
Door
Dead lock
Warning buzzer
Rear wiper
Alarm indicator
Turn signal and hazard warning relay
Interior (Dome) light (when interior light switch is at DOOR position)
Tail light relay
Front fog light relay (when lighting switch is at CLEARANCE position)
Rear defogger and mirror heater relays
Headlight low beam relay
Headlight low beam and tail light relays
Each door lock actuator
Each door lock actuator
Warning buzzer (in BCM)
Rear wiper relay
Theft deterrent light (in HVAC control module)
Body Electrical Control System:
Controlled Parts
10B-7