Suzuki GRAND VITARA JB416 Service Manual page 111

6) Tighten suspension frame mounting bolts (1) and
engine front body side mounting nuts (2) to specified
torque.
CAUTION
!
If reuse suspension frame mounting bolt,
apply engine oil to thread, bearing and trunk
surface.
Tightening torque
Suspension frame mounting bolt (a): 135 N·m (
13.5 kgf-m, 98.0 lb-ft)
Engine front body side mounting nut (b): 55 N·m
(5.5 kgf-m, 40.0 lb-ft)
2,(b)
1,(a)
7) Remove chain hoist from engine and the rope (1)
from the radiator (2).
2
8) Install hood referring to "Hood Removal and
Installation: in Section 9J in related manual".
9) Install front propeller shaft referring to "Propeller
Shaft Removal and Installation: in Section 3D in
related manual".
10) Tighten pipe bracket (1) bolts to specified torque and
then insert low pressure return hose (2) to low
pressure return pipe (3).
Tightening torque
Pipe bracket bolt: 11 N·m (1.1 kgf-m, 8.0 lb-ft)
11) Tighten union gear box bolt (1) to specified torque.
Tightening torque
Union gear box bolt (a): 35 N·m (3.5 kgf-m, 25.5
lb-ft)
I5JB0A220053-01
12) Connect steering lower shaft from pinion shaft
Steering referring to "P/S Gear Case Assembly
Removal and Installation: in Section 6C in related
manual".
13) Connect front height sensor connector (1) (if
equipped with head light auto leveling system) and
then detach clip (2).
1
I5JB0A220046-01
Front Suspension:
1
3 2
1,(a)
1
2
2B-19
I5JB0A220044-01
I5JB0A220054-01
I5JB0A220043-01