Table of Contents
Advertisement
Installing the controller into an i-Vu® Control System
You must complete the following procedures to successfully install your controller into an i-Vu® Control System.
Use the Help in the referenced software for detailed descriptions of these procedures.
EquipmentBuilder
Use EquipmentBuilder to create the control program for your controller.
1
If applicable, print the Sequence of Operation.
2
The i-Vu® or Field Assistant application
In the i-Vu® or Field Assistant interface, select the system level in the navigation tree.
1
On the Devices page > Manage tab, click Find Devices.
2
Select the controller in the list and click Upload. Wait until this is completed.
3
Click
4
Enter a name for your control program in Display Name and select the controller in the Controller drop-down
5
list.
NOTES You can change the control program's Reference Name if needed.
Do one of the following:
6
If the control program is...
In the Control Program drop-down
list
Not in the Control Program drop-
down list
To upload the graphic, click Add New under Views and browse to your .view file.
7
Click Continue. When message appears File added successfully, click Close.
8
Click Close again.
9
10 Right-click on the programmable controller in the controller list and select Check Status from the list. The
status of the controller should say File Mismatch.
11 Click the Download All Content button.
12 Configure the controller on the Properties page > Control Program tab.
13 Check out and commission the equipment.
Chilled Water System Optimizer v2
Installation and Start-up Guide
. A dialog window appears.
Select the control program.
a. Click Add New.
b. Browse to select the control program.
c. Click Open.
d. Click Continue.
e. Click Close.
21
Installing the controller into an i-Vu® Control System
CARRIER CORPORATION ©2019
All rights reserved
Advertisement
Table of Contents
