To Restore Factory Defaults - Carrier OPN-OPT-OL Installation And Startup Manual

If this LED is on...
Power
Link
LAN
100
Archive Valid
Port S1 transmit
Port S1 receive
Battery low

To restore factory defaults

CAUTION This erases all archived information and user-configuration settings. You will have to reconfigure
all custom settings. It is recommended to restore the factory defaults only under the guidance of Carrier Control
Systems Support.
To erase volatile memory data and restore factory default configuration settings:
Turn off the controller's power switch.
1
Make sure the address switches are not set to 0, 0.
2
Hold down the controller's Factory Defaults button while you turn its power on.
3
Continue to hold down the Factory Defaults button until the controller displays 8 and then the chase pattern,
4
then release the button.
Turn on the controller's power switch.
5
Chilled Water System Optimizer v2
Installation and Start-up Guide
Status is...
The controller has power..
The controller is connected to the Ethernet.
The Ethernet port is transmitting or receiving data.
The connection speed is 100 Mbps. If LED is not lit, the connection speed is 10
Mbps.
The controller's memory backup is valid.
The controller is transmitting data from
The controller is receiving data on
The battery is low.
29
.
Port S1
.
Port S1
CARRIER CORPORATION ©2019
Troubleshooting
All rights reserved