Table of Contents
Advertisement
Installing the Zone Ctrl II and VAV Zone II Secondary Duct into the i-Vu® application
Installing the Zone Ctrl II and VAV Zone II Secondary Duct into the i-Vu®
application
You must complete the following procedures to successfully install your Zone Ctrl II and VAV Zone II Secondary
Duct into the i-Vu® application. Use the Help in the referenced software for detailed descriptions of these
procedures.
EquipmentBuilder or Snap
1
Use EquipmentBuilder or Snap to create control program(s).
2
If applicable, print the Sequence of Operation, which includes the points list.
NOTE You can create a points list under Reports in the i-Vu® application or Field Assistant after installing
your control program.
This Installation Guide
1
Prepare a wire list using the points list. Refer to Appendix A (page 48).
2
Use the wire list and the following installation procedures to install and wire I/O points to your Zone Ctrl II
The i-Vu® or Field Assistant application
1
Upload the controller to the database by selecting the router in the navigation tree.
2
Select Devices > Manage tab.
3
Select the controller in the list on the page and click Upload.
4
If you are adding a new control program, click
5
Enter a name for your control program in Display Name and select your controller in the Controller drop-down
list.
NOTES
If you already have the maximum number of control programs for a controller, it will not appear in the
○
list.
Optional: You can change the control program's Reference Name if needed.
○
6
Do one of the following:
If the control program is...
In the Control Program drop-down
list
Not in the Control Program drop-
down list
Zone Ctrl II and
VAV Zone II Secondary Duct Installation and Start-up Guide
Error! No text of specified style in document.
. A dialog window appears.
Select the control program.
a. Click Add New.
b. Browse to select the control program.
c. Click Open.
d. Click Continue.
e. Click Close.
28
CARRIER CORPORATION ©2019
All rights reserved
Advertisement
Table of Contents
