Table of Contents
Advertisement
Point Name/Description
New Setpoint: ___ degrees — Displays value.
Setpoint was changed? — Enter status.
NOTE Change setting only when SETPOINT AVAILABLE displays in Operator
Instructions:.
Current Optimizer Setpoint: ___ degrees — Displays value.
Current Chiller Setpoint: ___ degrees — Displays value.
CONDENSER WATER SETPOINT - OPTIMIZATION
Optimizer Status: — Displays status.
PRE-START UP – optimizer doing pre-start calculations when first initiated.
○
FIRST RESET – optimizer is ready for first reset.
○
CALCULATING – optimizer is calculating next setpoint
○
NEW SETPOINT – optimizer has new setpoint and is ready for acceptance.
○
WAITING TURN – setpoint calculation is waiting when stagger is ON
○
PAUSE IS ON – displays when pause is ON.
○
WARM UP IS ON – displays when warm up is ON.
○
AUTOMATIC – displays when in AUTOMATIC mode.
○
Countdown until "New Setpoint" is determined: Displays value
Operator Instructions: — Displays status.
Elapsed time since "New Setpoint" is determined: ___ — Displays value.
New Setpoint: ___ degrees — Displays value.
Setpoint was changed? — Enter status.
NOTE Change setting only when SETPOINT AVAILABLE displays in Operator
Instructions:.
Current Optimizer Setpoint: ___ degrees — Displays value.
Current Condenser Setpoint: ___ degrees — Displays value.
Chilled Water System Optimizer v2
Installation and Start-up Guide
Appendix B: The Chilled Water System Optimizer Commissioning view of the Properties page
67
Range
R:
degrees
D:
NO
R:
NO/YES
R:
degrees
R:
degrees
R:
OFF
PRE-START UP
FIRST RESET
CALCULATING
NEW SETPOINT
WAITING TURN
PAUSE IS ON
WARM UP IS ON
AUTOMATIC
R:
(minutes:seconds)
R:
NO ACTION NEEDED
WAIT FOR RESULT
SETPOINT AVAILABLE
R:
(minutes:seconds)
R:
degrees
D:
NO
R:
NO/YES
R:
degrees
R:
degrees
CARRIER CORPORATION ©2019
All rights reserved
Advertisement
Table of Contents
